HOW TO CONVERT YOUR OBD1 AUTOMATIC
HONDA ECU IN TO A MANUAL ECU
THESE INSTALL INSTRUCTIONS WERE MEANT
ONLY FOR BUYERS FOR KITS BOUGHT FROM THE FOLLOWING TWO EBAY MEMBERS.
or
Kits bought from other sellers linked
you to my site illegally and most likely will not work for your kit anyways
because components do differ from seller to seller.
Remember as advertised in the auction
if you are not experienced with electronic components as well as soldering and desoldering then this kit is most likely
be too hard for you to install, please seek the assistance of someone
experienced enough to install this kit.
First make sure you have everything as
seen in the picture
RP18 - 0 ohm resistor (jumper wire)
Step 1: On an automatic ECU only,
locate the Auto / Manual selection area. This is under the external chip area.
Remove the resistors at RP18 and RP17.
Step 2: Desolder the holes for RP18.
Step 3: Install a 0 Ohm resistor in RP18.
Troubleshooting:
If you get a code 19 then you probably did not remove the resistor that was
in RP17, please look and make sure
This page is copywrited and belongs to the owner of theclubindustry.com.
Any pictures and/or text stolen from this page will be dealt with harshly to the
fullest extent of criminal and civil law.
